当前位置: 易推广 > 生物试剂/抗体/细胞 > 生化试剂 > 其他 > MedChemExpress > 产品展示 > MCE信号通路 > 其他 > FITC
FITC
企业档案
会员类型:会员
已获得易推广信誉 等级评定
(0 -40)基础信誉积累,可浏览访问
(41-90)良好信誉积累,可接洽商谈
(91+ )优质信誉积累,可持续信赖
易推广会员:8年
最后认证时间:
注册号: 【已认证】
法人代表: 【已认证】
企业类型:生产商 【已认证】
注册资金:人民币万 【已认证】
产品数:91228
参观次数:11393922
联系我们
MedChemExpress
电话:021-58955995
联系人:客服部 (请说明是在易推广看到的!谢谢)
手机:13611715263
邮编:201203
邮箱:sales@medchemexpress.cn
地址:上海上海
详细内容
MCE 的所有产品仅用作科学研究或药证申报,我们不为任何个人用途提供产品和服务。
FITC
CAS No. : 3326-32-7
MCE 站:FITC
产品活性:FITC,英文全称 Fluorescein Isothiocyanate,中文名称异硫氰酸荧光素,是生物学中应用*为广泛的一种绿色荧光素衍生物。FITC 具有高吸收率、优良的荧光量子产率和良好的水溶性等特点。FITC 的异硫氰酸基团可与蛋白质上的氨基、巯基、咪唑、酪氨酰、羰基等基团相结合,从而实现包括抗体,凝集素在内的蛋白标记。FITC 除了用作蛋白质标记物,还可用作蛋白质荧光示踪剂,通过标记抗体而快速鉴定病原体,或是用于蛋白质和多肽(HPLC)的微量测序。FITC 的激发波长为 494 nm。一旦激发,在发射波长 520 nm 处呈黄-绿色荧光。
研究领域:Others
作用靶点:Fluorescent Dye
In Vitro: Protocol
1.Protein Preparetion
1) In order to obtain the best labeling effect, please prepare the protein (antibody) concentration as 2 mg/mL.
2) The pH value of protein solution shall be 8.5±0.5. If the pH is lower than 8.0, 1m sodium bicarbonate shall be used for adjustment.
3) If the protein concentration is lower than 2mg/ml, the labeling efficiency will be greatly reduced. In order to obtain the best labeling efficiency, it is recommended that the final protein concentration range is 2-10 mg/mL.
4) The protein must be in the buffer without primary amine (such as Tris or glycine) and ammonium ion, otherwise the labeling efficiency will be affected.
2.Dye Preparation
Add anhydrous DMSO into the vial of FITC to make a 10 mM stock solution. Mix well by pipetting or vortex.
3.Calculation of dye dosage
The amount of FITC required for reaction depends on the amount of protein to be labeled, and the optimal molar ratio of FITC to protein is about 10.
Example: assuming the required marker protein is 1 mL 2 mg/mL IgG (MW=150,000), use 1 mL DMSO dissolve 1 mg FITC, the required FITC volume is 40 μL.
4.Run conjugation reaction
1) A good volume of freshly prepared 10 mg/mL FITC is slowly added to 0.5 mL protein sample. In solution, gently shake to mix, then centrifuge briefly to collect the sample at the bottom of the reaction tube. Don't mix well to prevent protein samples from denaturation and inactivation.
2) The reaction tubules were placed in a dark place and incubated gently at room temperature for 60 minutes at intervals.For 10-15 minutes, gently reverse the reaction tubules several times to fully mix the two reactants and raise the bar efficiency.
5.Purify the conjugation
The following protocol is an example of dye-protein conjugate purification by using a Sephadex G-25 column.
1) Prepare Sephadex G-25 column according to the manufacture instruction.
2) Load the reaction mixture (From "Run conjugation reaction") to the top of the Sephadex G-25 column.
3) Add PBS (pH 7.2-7.4) as soon as the sample runs just below the top resin surface.
4) Add more PBS (pH 7.2-7.4) to the desired sample to complete the column purification.
Combine the fractions that contain the desired dye-protein conjugate.
Note
1. FITC is sensitive to light and humidity. Immediately add FITC solution and discard the unused part.
2. Low concentrations of sodium azide (≤3 mM or 0.02%) or thiomersal (≤0.02 mM or 0.01%) did not significantly interfere with protein labeling; However, 20-50% glycerol will reduce labeling efficiency.
3. Avoid buffering with primary amines (e.g., Tris, glycine) or ammonium ions,It compete with labeled proteins.
4. This product is only for scientific research by professionals, and shall not be used in clinical diagnosis or treatment, food or medicine.
5. For your safety and health, please wear lab coat and disposable gloves.
相关产品:MeOSuc-Ala-Ala-Pro-Val-pNA | BDP 558/568 amine | AC-green | Naphthalene-1,2-dicarbaldehyde | Rhodamine 800 | Vari Fluor 532 SE | Acridine Orange hydrochloride | N-(7-Nitrobenzofurazan-4-yl)phallacidin | Biotin-11-UTP | BODIPY FL SSE | 1,2-Diamino-3,4-ethylenedioxybenzene | Sulfo-Cyanine5.5 NHS ester tripotassium | BODIPY 505/515 | 3-Acetylumbelliferyl β-D-Glucopyranoside | Ac-DNLD-AMC | Mucicarmine | 7-Aminocoumarin | NEP | Sulfo-cyanine3 azide sodium | Dihydrorhodamine 123 | Allophycocyanin | N-Acryloyl-1-pyrenebutylamine | TSPP tetrasodium | Dabcyl acid | 7-Diethylamino-4-methylcoumarin | 9-(2-Carboxy-2-cyanovinyl)julolidine | RT-NH2 | Coumberol | Carmoisine | 4-Methylumbelliferyl-N-acetyl-α-D-glucosaminide
热门产品线:重组蛋白 | 化合物库 | 天然产物 | 荧光染料 | PROTAC | 同位素标记物 | 寡核苷酸 | 抗体 | 点击化学
Trending products:Recombinant Proteins | Bioactive Screening Libraries | Natural Products | Fluorescent Dye | PROTAC | Isotope-Labeled Compounds | Oligonucleotides | Antibodies | Click Chemistry
品牌介绍:
• MCE (MedChemExpress) 拥有200 多种全球独家化合物库,我们致力于为全球科研客户提供前沿*全的高品质小分子活性化合物;
• 50,000 多种高选择性抑制剂、激动剂涉及各热门信号通路及疾病领;
• 产品种类涵盖各种重组蛋白,多肽,常用试剂盒 ,更有 PROTAC、ADC 等特色产品,广泛应用于新药研发、生命科学等科研项目;
• 提供虚拟筛选,离子通道筛选,代谢组学分析检测分析,药物筛选等专业技术服务;
• 设有专业的实验中心和严格的质控、验证体系;
• 提供 LC/MS、NMR、HPLC、手性分析、元素分析等各项质检报告,确保产品的高纯度、高品质;
• 产品的生物活性多经各国客户实验验证;
• Nature, Cell, Science 等多种期刊及制药收录了MCE客户的科研成果;
• 专业团队跟踪*新的制药及生命科学研究进展,为您提供全球*新的活性化合物;
• 与世界各大制药公司及知名科研机构建立了长期的合作。