产品展示
人肺炎支原体（MP）IGMELISA试剂盒厂家
点击次数：14发布时间：2016/8/17 17:26:38
更新日期：2016/8/17 17:26:38
所 在 地：中国大陆
产品型号：
优质供应
详细内容
【友情提示】：本产品仅供科研研究使用，不得用于人体临床直接检测。避免给您带来不必要的损失，请仔细阅读购买说明！
【人肺炎支原体（MP）IGMELISA试剂盒厂家】酶法检测试验所需自备物品:
1. 酶标仪(450nm 波长滤光片)
2. 高精度移液器，EP 管及一次性吸头
3. 37℃恒温箱，双蒸水或去离子水
4. 吸水纸
试剂盒安全性提示：
1.工作人员实验中避免直接接触终止液和底物A、B。一旦接触到这些液体，请尽快用水冲洗。
2.实验中不要吃喝、抽烟或使用化妆品。
3.不要用嘴吸取试剂盒里的任何成份。
【人肺炎支原体（MP）IGMELISA试剂盒厂家】操作注意事项：
1.试剂盒应按标签说明书储存，使用前恢复到室温30分钟后方可使用。稀稀过后的标准品应丢弃，不可保存。
2.实验中不用的板条应立即放回包装袋中，密封保存，以免变质。
3.不用的其它试剂应包装好或盖好。不同批号的试剂不要混用.请在试剂盒保质前使用。
4.使用一次性的吸头以免交叉污染，吸取终止液和底物A、B液时，避免使用带金属部分的加样器。
5.使用干净的塑料容器配置洗涤液。使用前充分混匀试剂盒里的各种成份及样品。
6.洗涤酶标板时应充分拍干，不要将吸水纸直接放入酶标反应孔中吸水。
7.底物A应挥发，避免长时间打开盖子。底物B对光敏感，避免长时间暴露于光下。避免用手接触，有毒。实验完成后应立即读取OD值。
8.加入试剂的顺序应一致，以保证所有反应板孔温育的时间一样。
9.按照说明书中标明的时间、加液的量及顺序进行温育操作。
【人肺炎支原体（MP）IGMELISA试剂盒厂家】齐一生物客户寄标本时需注明以下情况：
1、标本编号；2、所测项目；3、是否做复孔；3、联系方式；4、实验后标本是否寄回。
客户必知：
客户应对所提供的材料及信息负责，如因客户提供的材料及信息不准确而引起的实验延误或经济损失由客户承担。
齐一生物供应ELISA试剂盒检测的目的是为实验提供准确可靠的定量分析实验依据。为了保证实验数据的可靠性，在实验过程中必须坚持全面质量控制和全过程质量控制。在收集标本前都必须有一个完整的计划。
样本保存条件：
1.2-8℃冰箱*多放2周
2.-20到-50℃的冰箱可以放3-6个月
3.-50℃以下的冰箱，可以放一年
样本收集
1.血清样本用干燥管（红色）或者促凝管（黄色）收集
2.血浆用抗凝管，一般有EDTA抗凝（紫色）、枸橼酸钠抗凝（黑色或者蓝色）
3.动物组织匀浆（细胞）：
1g组织加入9ml PBS（浓度为0.1M，pH为7.4的）测分泌型指标
1g组织加入1ml组织裂解液加入8ml PBS 测细胞内
粪便样本：1g样本+9ml PBS（浓度为0.01M，pH为7.4的）
没有PBS的话也可以用一下生理盐水，还是用PBS
样本离心转速及时间
1.试管采集的样本：3000转，离心五分钟取上清
2.离心管或者EP管采集的样本：5000－－8000转3分钟取上清
3..样本保存－－如果样品不立即使用，应将其分成小部分-70 ℃保存，避免反复冷冻。尽可能的不要使用溶血或高血脂血。如果血清中大量颗粒，检测前先离心或过滤。不要在37℃或更高的温度加热解冻。应在室温下解冻并确保样品均匀地充分解冻。
【人肺炎支原体（MP）IGMELISA试剂盒厂家】齐一生物供应，以上资料供参考如有疑问需要详细资料请联系我们客服人员，齐一生物销售：021－6034 8496；181214 53965；173021 04490
9020016 Cable harness, VacuumStation PCB, CX1 CNY
9019938 Opto switch, P-axis, 1 ch. , Cx2 CNY
9019486 HEPA filter, replacement cartridge, Cxx CNY 【人肺炎支原体（MP）IGMELISA试剂盒厂家】
9238861 BR 8000, Premium Agreement The Premium Cover Agreement 8000 provides full service coverage for the BioRobot 8000. Costs for service visits are fully covered including travel, labor, ａnd parts. The agreement also includes one annual preventive maintenance visit, with costs for labor ａnd parts covered. With a Full Agreement, there is a priority response time of 24 hours (1 working day). CNY
9238855 BR MDx, Basic Agreement The Basic Cover Agreement MDx provides full service coverage for the BioRobot MDx. Costs for service visits are fully covered including travel, labor, ａnd parts. The agreement also includes one annual preventive maintenance visit, with costs for labor ａnd parts covered. With a Basic Cover Agreement, the response time is 5 working days. CNY
9238850 EZ1, Basic Agreement The Basic Cover Agreement EZ1 provides full service coverage for the BioRobot EZ1. Costs for service visits are fully covered including travel, labor, ａnd parts. The agreement also includes one annual preventive maintenance visit, with costs for labor ａnd parts covered. With a Basic Cover Agreement, the response time is 5 working days. CNY
9241226 Barcode Reader, EZ1a CNY
9238812 Rectangular carrier, undrilled CNY
9019467 PLATE GLASS SHORT SET GS CNY
9019465 Pads, D=10mm, white (85), Cxx CNY
9019459 Transformer (115V), HS CNY
9233429 Valve, magnet, dispenser, BR8000 CNY
9233334 Solenoid Valve, 5-fold CNY
9237332 Install, BR plus 2 integr. w. scheduling Installation ａnd training, BioRobot System including two approved integration devices with scheduling CNY
9237167 Bottom Air Filter CNY
9232994 Board, LED, BR8000 CNY
9237158 RTD Adapter Board XYP CNY
9237152 Power Inlet CNY
9237108 Protocol Dev./Opt., on-site (4-days) The QIAGEN BioRobot Systems Protocol Development/Optimization On-Site Visit includes all travel ａnd labor charges for a site visit up to 4 days by a QIAGEN Instrumentation Service Specialist to write and/or opimize protocols for the BioRobot System. Parts, consumable chemistries, ａnd accessories not included. Custom protocols are the sole responsibility of the customer ａnd neither warrantied nor guaranteed. CNY 【人肺炎支原体（MP）IGMELISA试剂盒厂家】
9237098 Upgrade QIAsoft, on-site CNY
9242092 QIAgility, Inspection Agreement CNY
9236425 Motor, vertical, TWI CNY
9236423 Belt, rotary, TWI CNY
9236413 Storage Pod TW II CNY
9232979 PCB, Main, Incubator CNY
9232969 YZ 96-Connector Board 1 (Arm), E10102 CNY
9236159 Motor, rotary, repl. kit, RapidPlate CNY
9236143 RS232 Bypass Tool CNY
9236108 Manual, User, English, Plato 3 CNY
9235773 Reagent Holder, 2-trough, 20 ml Holder for accommodating 2 disposable troughs. For use with Buffer AL ａnd ethanol on the BioRobot MDx CNY
QT-00112 运动发酵单孢菌ATCC29191 冻干粉
QT-00113 假单胞杆菌ATCC31554 冻干粉
QT-00114 粪产碱杆菌ATCC31555 冻干粉
QT-00115 菅囊酵母ATCC32691 冻干粉
QT-00116 弗氏柠檬酸杆菌ATCC10787 冻干粉 【人肺炎支原体（MP）IGMELISA试剂盒厂家】
QT-00117 荚膜红细菌ATCC11166 冻干粉
QT-00118 发根土壤杆菌（发根植物单胞菌）ATCC11325 冻干粉
QT-00119 生孢梭菌（产芽孢梭状芽孢杆菌）ATCC11437 冻干粉
QT-00120 痤疮丙酸杆菌ATCC11827 冻干粉
QT-00121 地衣芽孢杆菌ATCC11946 冻干粉
QT-00122 谷氨酸棒杆菌ATCC13032 冻干粉
QT-00123 熏衣草灰链霉菌ATCC13306 冻干粉
QT-00124 猪霍乱沙门氏菌猪霍乱亚种ATCC13312 冻干粉
QT-00125 脱氮假单胞菌ATCC13867 冻干粉
QT-00126 耐放射异常球菌ATCC13939 冻干粉
QT-00127 绿针假单胞菌ATCC13985 冻干粉
QT-00128 肠炎沙门氏菌肠炎亚种ATCC14028 冻干粉
QT-00129 巨大芽孢杆菌ATCC14581 冻干粉
QT-00130 吸水链霉菌奥萨霉素亚种ATCC15420 冻干粉
QT-00131 长双歧杆菌ATCC15707 冻干粉
QT-00132 放射性根瘤菌ATCC15955 冻干粉 【人肺炎支原体（MP）IGMELISA试剂盒厂家】
QT-00133 短密青霉ATCC16024 冻干粉
QT-00134 副溶血性弧菌ATCC17802 冻干粉
QT-00135 单核增生李斯特菌ATCC19115 冻干粉
QT-00136 缺陷短波单胞菌ATCC19146 冻干粉
QT-00137 师岗链霉菌ATCC19166 冻干粉
QT-00138 脱氮付球菌ATCC19367 冻干粉
QT-00139 丝状链霉菌ATCC19753 冻干粉
QT-00140 裂殖壶菌ATCC20888 冻干粉
QT-00141 产朊假丝酵母ATCC22023 冻干粉
QT-00142 乙酸钙不动杆菌ATCC23055 冻干粉
QT-00143 珊瑚链霉菌ATCC23901 冻干粉
QT-00144 菲律宾链霉菌ATCC23905 冻干粉
