您好,欢迎来到易推广 请登录 免费注册

深圳市赛德力检测设备有限公司 主营产品:CMM1-2T美蓓亚传感器,CBE1-20K,U3B1-100K-B,CSD-815B日本Minebea仪表,德国劳恩-梅斯泰克lorenz-messtechnik动态扭矩传感器DR-2412-R,日本瓜生URYU瓜生气动螺丝起子US-LT30B-11

当前位置: 易推广 > 光学仪器 > 激光仪器 > 激光器 > 深圳市赛德力检测设备有限公司 > 产品展示 > 美国 > 美国LUMINA > 美国LUMINA卢米纳大功率激光二管驱动器6000W激光电源

美国LUMINA卢米纳大功率激光二管驱动器6000W激光电源

价格:¥电议

品牌名称:$brandModel.Title(进口品牌)型号:LDD-6000-XX-YY 原产地:中国大陆 发布时间:2024/3/28 14:43:58更新时间:2024/11/26 9:01:10

产品摘要:美国LUMINA卢米纳大功率激光二管驱动器6000W激光电源LDD系列高功率激光二管驱动器是为新兴的高功率激光二管工业而设计的OEM激光二管驱动器的新家族。LDD系列大功率二管激光驱动器是高功率应用的理想驱动器,在高功率应用中,经济性很重要,性能不受影响。由于低损耗的零电压开关逆变器和平面磁学的加入,紧凑的尺寸是可能的。

产品完善度: 访问次数:177

企业档案

会员类型:会员

已获得易推广信誉   等级评定
41成长值

(0 -40)基础信誉积累,可浏览访问

(41-90)良好信誉积累,可接洽商谈

(91+  )优质信誉积累,可持续信赖

易推广会员:11

工商认证 【已认证】

最后认证时间:

注册号:**** 【已认证】

法人代表: 【已认证】

企业类型:经销商 【已认证】

注册资金:人民币***万 【已认证】

产品数:2753

参观次数:3135758

手机网站:http://m.yituig.com/c96142/

旗舰版地址:http://www.szsaidelq.com

土耳其OPKON位移传感器

测试系统

多点压力分布测试系列

美国

CTAPLUS

NBK

韩国奥托尼克斯

韩国

意大利

台湾

赛德力

加拿大

德国

德国wazau

日本

日本KYOWA

日本MTO

日本NTS

日本共和kyowa传感器

日本SHOWA

日本Minebea-NMB传感器

英国

新加坡

美国AC

TS

详细内容

 美国LUMINA卢米纳大功率激光二管驱动器6000W激光电源

美国LUMINA,卢米纳,大功率激光二管驱动器,6000W激光电源

参数规格

The LDD-6000 laser diode driver is intended for OEM laser applications using highpower diode lasers. It has been designed to be integrated into systems formaximum performance at a cost far below traditional laboratory and scientificdiode laser drivers.The LDD-6000 takes any three phase AC input from 200VAC to 480VAC, 50/60Hz.The output inverter is a state-of-the-art zero voltage switching (ZVS) inverterwhich permits very high frequency power conversion with minimum losses.As a diode laser driver, the LDD-6000 power supply acts as a current source anddelivers constant current based on the input program signal, Iprogram(+), whichis normally 0-10V. An optional RS-232 interface is available. All units areconfigured with a maximum current and maximum voltage capability, dependingon the user’s requirements. LDD-6000 will deliver current, as programmed, intoany load, providing the voltage requirements of that load do not exceed themaximum rated voltage of the unit. When the required compliance voltage ishigher then the maximum rated output voltage of the unit, the unit will limit The LDD-6000 has been designed specifically for the OEM high power CW laserdiode systems. OEM power supplies for the laser diode industry have thefollowing requirements: Safe laser diode operation Broad range of control of output current Safe rise/fall times Auxiliary power supplies to simplify overall laser system design Low conducted electromagnetic emissionsReferring to Figure 1, the “LDD-6000 Laser Diode Driver Block Diagram”, thefollowing is a brief description of operation.AC Input Power CircuitryInput voltage: 3 phase and GND. No Neutral.AC input power is processed through a line filter to reduce the conducted EMI toan acceptable level. The LDD-6000 line filter has minimum capacitance to groundto minimize leakage currents. Earth Ground stud is provided near the AC inputterminals and should be connected to the system ground.The LDD-6000 can take any AC input voltage of either 200 – 240VAC or 380 –480VAC and the internal jumpers have to be selected correctly. The powersupply will not fail but will not work if the jumpers are not correctly selected andthe red LED near the AC input terminal will be seen and the safety relays will notclosed.Upon applying the mains, the fans will start and the safety relays will close after adelay of a few seconds if the power supply is healthy and ready to operate.Zero Voltage Switching (ZVS) InverterThe ZVS inverter and the output transformer are used to step the rectified 3phase voltage bus to the appropriate output value. The ZVS inverter is the mostmodern high frequency/low loss/low noise ology utilized in power electronicstoday. Instead of running the inverter in a traditional PWM mode, the inverter isrun in a phase shift mode. With the appropriate output inductor and theappropriate capacitance across each switching device, in this case MOSFETS,there are virtually no switching losses in the inverter. The only losses in thedevices are I2R losses associated with the Drain/Source resistance of the MOSFETS. Therefore, the ZVS inverter also contributes to reduced losses,reduced EMI noise and a reduction in overall system heat sink requirements.Output CircuitThe output filter is a two stage LC filter designed to keep ripple and output noisevery low. The filter has very small capacitors to prevent high current spikes incase part of the laser diode array fails shorted.Control CircuitThe control circuit handles all the responsibilities associated with safe operation ofthe laser diode. Controlled rise and fall times, as well as tight current regulation,overvoltage and ov

快速导航

在线咨询

提交