*大限度地减少摩擦和震颤噪声

为超敏感电流和电荷测量而设计的

噪音水平减少1000倍

高屏蔽同轴设计

与上等连接器充分组装

超高绝缘电阻>1014Ω -baozheng

可用长度：0.1米，0.2M，0.5米和1米

自定义长度可供选择：10条*小起订量

德国FEMTO低噪音电缆系列CAB-LN1-BB-150进口电流放大器

MICROPHONIC NOISE

Mechanical influences on a cable (vibration, sound waves, friction, bending etc.) can induce electrical charges by triboelectric effects leading to significant extra noise typically in the low frequency range from quasi-DC up to 100 kHz. When measuring very low currents in the nano-, pico- ａnd femtoampere region this microphonic noise may become the dominating noise source.
Even when located in a relatively quiet ａnd silent environment any micro-movement of the cable can produce significant noise levels making a real low noise signal measurement impossible.

NOISE REDUCTION BY A FACTOR OF 1,000

FEMTO´s low noise cables are manufactured with a special semi-conductive layer between the dielectric ａnd shield to counteract effectively the microphonic noise. The careful test ａnd evaluation process we have performed in our femtoampere-laboratory showed our CAB-LN1 cable being the best-in-class cable also in comparison to many low noise cables available in the market. Due to the superior cable design the noise reduction compared to ordinary e.g. RG58 or RG174 cable is typically more than 1,000 times.

INSULATION RESISTANCE > 1014 Ω – 100% TESTED FOR EACH CABLE

Performing low current or low charge measurements requires signal cables with very high insulation resistance in order to avoid additional thermal resistance noise. A high insulation resistance is also important for preventing the low currents/charges from flowing to ground (shield) ａnd therefore not contributing to the signal measurement. The cable used in the CAB-LN1 series is a very high insulation type. In addition all FEMTO low noise cables are equipped with ultra-high insulation connectors preserving the high insulation resistance also for the completely assembled cable. Before shipping each cable is thoroughly tested to meet the insulation resistance specification of > 1014 Ω.

 APPLICATIONS

§  Measurements of low currents down to femto amperes

§  Photodetectors ａnd ionization detectors

§  High resistance measurements

§  Scanning probe microscopy (STM, SPM, STS)

§  Spectroscopy

§  Piezo- ａnd pyroelectric transducers

产品型号列表

德国FEMTO低噪音电缆系列CAB-LN1-BB-150进口电流放大器